Show messages:
1-14
…
595-614
615-634
635-654
655-656
From: Mindset (IGNITER)
Hello Michael,
The ability to lock-down portions of curve when editing by control-points would be wonderful.
Could fit/position one portion of the curve and then set to have that portion resist any change while adjusting its adjoining portion.
The Lock Command
doesn't seem to work on control points. Maybe some other function might be required.
Hope this can work.
Thanks for all that you do!
Image Attachments:
Lock Command.png
From: Michael Gibson
Hi Mindset,
re:
> The Lock Command doesn't seem to work on control points.
Yes, control points don't have the full set of object properties like name, hidden, locked, styleindex, etc...
It's problematic to have those because it's not unusual for surfaces to have several thousand control points and having a full set of object properties for each one could potentially increase memory consumption by a large amount.
It could also cause a lot more calculation to happen for the scene browser.
- Michael
Show messages:
1-14
…
595-614
615-634
635-654
655-656
