I tried making one surface with Rhino imported curves and other one natively in MOI.

I must say the result is the same. Please not misunderstand. The sweep was always performed by MOI which looks neater.

I am just thinking that I could import all my lines from Rhino. I just wanted to check if this is as expected to happen. As long as the procedure is performed by Moi the structure in Rhino will not change the behavior in respect to the one made in Moi.


Thanks a lot.

You can check here.

Red one is coming from Rhino. Grey Moi. In order to see the isocurves I imported to Rhino again both.