Greetings everyone! First post on the forum, so noob alert :)

I'm trying to create a shape using sweep, and i ran into weird problem: some of the "seams" do not match correctly.

If you load the attached file, you will notice that the red and white parts do not match.

What is the "correct" (= easy) way to create something like this? I first created the lower face using the "profile" and "rail" curves with the Sweep. Then i tried to use the border from Sweep's result as a rail for the "bevel" shape, but it did not work. So i extruded the shape, used Fillet for the corners, removed the borders and finally used bottom border as a rail for the shape, one side/corner at the time.

Thx
/Kimmo