I would like to set up my Connexion device to work like SketchUp (and other programs) where the mouse 'knob' is the actual object. So if you rotate right the object spins left--just as if you were holding it in your hand. This works fine in MoI by checking the 'reverse rotation' but then for this to work, I need to also check a box 'reverse tilt' but none is available. And for some reason, the Mac drivers control panel setting can't overide the internal MoI settings.

1. Is there any way to do set it up so that the tilt is reversed?
2. Is there any way to *disable* the MoI Connexion settings and allow the Connexion control panel take over?