Brake caliper modelling
From:
ArianDesign (ARIANSHAMIL)
7 Sep 2014 (4 of 40)
6900.4
In reply to
6900.3
Ciao!
here some of the upgrades that i've done today ;)
I did some particular on the upper side....
Then i did a big fillet by sweep on the lower side then i've added the two fixing holes and to the end i added two reinforcing rib.
And then i added a lot of fillets to the caliper body, two new parts (a clip and a pin) and i did the pistons holes.
;)
Attachments:
10a.jpg
1a.jpg
2a.jpg
3a.jpg
4a.jpg
5a.jpg
6a.jpg
7a.jpg
8a.jpg
9a.jpg