All,
I'm working on a model of a BQM-34A Firebee, an aerial target drone for the Military.
Here is what the real thing looks like.
I'm having some difficulty when trying to combine 3 shapes that make up the engine intake.
Here is a snapshot in MOI of the intake.
Now, when I Trim away the unwanted curves and Join it altogether, I end up with corner points, mainly at the Arcs.
Here it is before I Join the sections.
And here it is after Joining. This looks odd in and of itself, because of the point spacing on the circle.
This didn't happen originally. It showed up as I was preparing my question. I'm not sure of what is going on here either, anyway.
And finally here are the strange corners that I wind up with.
I'm using the Jun-27-2014 beta build.
How can I create this without corner points?
Is there a better way?
Thanks in advance for any help.
Scott
|