Hi Martin,

> I've just noticed that doing a Tapered Extrude with Cap ends deselected isn't obeyed at the
> moment and a solid's created instead of just the sides.

Yeah "Cap ends" is not used for tapered extrude currently, you should see the "Cap ends" checkbox itself disappears once you activate the tapered extrude mode.


> Would this 'Planar sections' technique work within the Nsided tool for areas that come
> out slightly distorted?

I don't think I can apply it to Nsided because the method of construction that Nsided uses is much different than Blend, NSided does not do a fully cross section lofting style construction method like Blend does.

- Michael