Hi Claas,

> Michael is in such a situation it possible to have the side shells mesh as is but have more subdivision
> along U or V of the edge rounding geometry so that the mesh flow between sides and edge is more
> consisten?

It's unfortunately quite difficult to have the mesh created as if it had human judgement about where to place vertices.

In the general case there is not necessarily any special U/V alignment between different surfaces, start drilling some holes through your blend areas and you can easily see what kind of general geometry the mesher has to be able to deal with.

It could be possible in the future to have special case handling of certain situations, but they have to be detected and categorized properly and it's not easy to do such things.

- Michael