One for Micheal
I am assuming this feature is not already in there . .. when drawing a line, circle, square etc you can see the current dimension appearing in the info bar and the tool properties. I would like to see a way of setting a snap so that say with the shift key pressed it would draw in say 1mm or 5mm units. A bit like a grid snap. For me ideally it would be on 1mm increments. Say I draw a 32mm circle, i always have to select circle after drawing and type in 32 or type in the info box at bottom. I would like to remove this step so its all done in the drawing action.
Hope thats clear. If it can already be done I hold my head in shame and marvel at how dam good this software is!
Matt
|