Incremental angle.

 From:  DannyT (DANTAS)
Hi Michael,

Hope all is well, I've been extremely busy for a while reason why I haven't been on the forum lately, had a scroll through and it looks like there's been a lot of activity going on especially with some of the models the guy's have been producing.....well done guy's quality stuff!

Anyhow, I've had a chance to do some leisurely MoI modelling, and lovin it by the way, as I was laying out some lines I needed them to be at particular rounded off angles like 5°, 10° etc. I do use the function (TAB <5 ENTER) to get the angle I want but doing a lot of lines gets a bit non flowing like, so I was thinking could there be a field in the Line command where we could place an incremental angle when drawing lines, if you place the number 5 in the field then all lines will be drawn at 5° increments.