Extrude again

 From:  blowlamp
5673.3 In reply to 5673.2 
> >The past 2 months or so have been taken up pretty much entirely by researching different n-sided patch mechanisms for filling in holes with irregular boundaries.

I wish you all the best with what you're doing there, Michael.

I remember the thread where you went through some of the options available to you and there were good and bad bits in all the current methods, but no totally good single solution.

If you can eventually come up with something that meets your expectations, then we can be pretty sure it'll be better than almost anything else, no matter the price - it must be some undertaking!

Martin (2).