Hi,
I'm a still bit of a noob I am afraid, so I am again asking for advise.
I have this curve that has a trim that I don't want any more, but I cant seem to get rid of it.
Is there any trick I can use - or must I remake the whole curve again from scratch? ( I forgot how I made it)
It's the thin cut out bit bit circle in red. I have draw a line across where it should be.

I know I could just make a new network to fill it in, but that will not be good for meshing export as I want lowest poly count.
Any ideas?

I am having great success with the program making some low poly models by the the way, the meshing is very good.
Thanks for making this great program Michael!

Thanks
Pete