modeling discussion

 From:  Michael Gibson
5098.2 In reply to 5098.1 
Hi Burr, I don't quite understand where some of the measurements are coming from.

For this one: "The cone shape should be 30 degree's."

Do you mean the radius of a cone as measured like this: ?

Then for this one: "The scallops should be 25 degrees." I don't understand where you're talking about that measurement - the angle between which 2 lines should be 25 degrees?

Do you maybe mean these angles are between either the side edges of each scallop and the center line of the base cylinder, and the other measurement is from the line in the middle of the curved scallop to the center line of the base cylinder?

- Michael