Thanks a bunch Frenchy!
EDIT
After Frenchy's discovery. I went back and did it from scratch at a higher resolution, and I still wound up with some of my curves overlapping, and points not touching.
I dunno how to address it. But, the workaround is..I joined the curve together starting with small sections of the curve, until I find a section that wont join. Which ends up either being an overlap, or the connecting points being off by a small amount. Once I fix the issue, I continue joining until the curve is closed. With the final test being if the Planar command will create a surface.
Any suggestions on the workflow?
-TS-
|