Thanks. I worked on it last night and now am able to save the file and move it to cut 3D. Thank you.

I am getting closer but I still have a long way to go in drawing the object. Suggestions appreciated.

The wood will be a 2x6 flat side on table and suspended with fixtures so I can turn it over and do the other side. This description might be unclear and I am not sure how to post a picture of what I am trying to make. Hope some of the this makes sense.

The wood, as it goes from left to right will get smaller in the y and Z axis and then flare out wider. The corners will be rounded on most sides with a few curves cut and radiused toward the middle portion.

Tony