MMCX Connector Tut?

 From:  OSTexo

For some reason the Flow command to do the knurling is not working as well as it did in a previous beta. I'm getting some very weird problems now with stretching, edges not lining up and such and it seems to be running slower. I've found that the Twist command is a bit more suited now to making knurling at this point but also have a few issues with that as well when cutting away surfaces, such as missing faces and bad Booleans that clear up once I shrink the surfaces, and then crop up again. It's kind of hard to pin down since the errors are not kicking off reports to email, but the Twist command is what I'm using at this point with the current beta.