Hi Burr,

> A "bulge slider" for twist..... (well, 2. One for
> in and one for out)

The other problem with this is that it would probably mean adding in an extra step to the entire Twist command flow just so you could possibly tweak this value.

Right now the way it goes is you enter in a twist angle and once you do that you're all finished...

It doesn't seem very good to add in an entire extra stage just for twist acceleration tweaking.


I think it will be possible to add an option though to limit the twist to only happen inside of the axis range and when you do that there will be an automatic gradual ease-in/ease-out built in, here's an example twisting just the upper half of this thing:



Or here with twisting only the middle area:



That will allow for things like this - limited range twist with a twist axis between these 2 points:





- Michael