Hi Mike,

> I could imagine a check box in the dialog box like
> the one on the Spiral command, where if you check it
> you could then pick a twist angle at one end and then
> at the other.

I don't think that will work though - in the spiral command you're picking 2 different radius values - in the twist command you don't pick any radius values at all, because the distance of the particular point being deformed away from the axis is actually used as the radius of the helix.

Since it is a deformation that is being applied to objects, it's a bit of a different thing than drawing a single curve like the spiral.

Right now I can't see how 2 different twist angle would work - I mean the way twist works is that at the base of the twist axis you get 0 rotation there and it goes up to the full angle at the top. To do "ease in/ease out" doesn't really mean to change the start or end angle so much as it would mean changing how the transition between them would work...

Controlling the transition speed is not really the same thing as specifying 2 different angles...

- Michael