Curve Import in Version 3

 From:  Michael Gibson
4460.3 In reply to 4460.1 
Hi Drakonsden,

> Will the import of 2D Curves in DXF or DWG be added to version 3?

I'm not sure yet. I can probably say probably not DWG - DWG is difficult to deal with since it is not publicly documented by Autodesk, so it requires some special libraries to really deal with it well.

For DXF, I do want to work a 2D DXF export during v3. I'm not sure about an importer as well - typically an importer is a lot more work than an exporter so I am uncertain at this time if I will be able to do that for v3 or not.

- Michael