re: Flow - I've managed to get the surface-to-surface flow working with a lot better quality.

You basically set up some objects and have them arranged on a base plane, then you run the Flow command, pick the base plane and then pick the target surface and the objects morph from the base surface to the same relation on the target surface.

Here are some examples:







Here's a pattern that was easy to do all flat:



Then using a sphere or a tube as the target surface:



Will give a result like this:




Now I actually need to get the curve-to-curve one (flowing between base spine curve to target spine curve) up to the same level of quality. At the moment the surface to surface one is actually working best, the curve-to-curve one is still a bit lumpy.

- Michael