Hi Pilou,

this is kind of annoying, I've set this mesh angle thing to only 2 and check the add details checkbox.

But if you look at the leg from the back or the right, shouldn't the middle edge be perfectly horizontal??? The way I visualize the leg, these 2 lines should be strait and horizontal. The one (edge) that's shows in the front view at an angle shouldn't be there in my mind, that surface should be nicely flowing from top to bottom. The original leg was veneered with some nice figured wood on that face so I assume that the surface was nicely flowing from top to bottom!

This is why I'm trying to figure out how and or if it can be done using MOI???

Thanks,
Felix