Problem part of a network surface

 From:  davidb45
4288.7 In reply to 4288.6 
Michael,

Thanks to your email- the problem is solved.

The problem I was having is that after the trim/delete is done the newly created curve did not highlight when moused over
as other curves or lines do. I didn't initially understand that the network needs to be highlighted first before the curve(s) will highlight.
This may have been because, as you pointed out, the new curve was fragmented. Once I did a Join on the two segments, the new curve
would highlight as any other curve does.

Looking forward to completing the project.

Thanks again.