mesh edges not aligned when exporting Closed

 From:  steve (STEVE_HOME)
3869.58 In reply to 3869.57 
Hi FlashFire,

Sorry, I missed your reply/question.

For that model I just used lines to trim the surfaces. For some models it can take longer to split up the surfaces than actually building the model. But if that is the type of output wanted, then that it what I do.

I did have a look at Topogun due to Michaels post (I had been meaning to look at that program for a while). The program is very easy to use, but find that it would take a lot longer to produce the type of output I want, than it takes me in MOI

- Steve