From:  Mark Brown (MABROWN)
3059.6 In reply to 3059.5 
Some progress on brave little Yarra.

One thing I will do better next hull is to look out for tell tale visual "streaks" in the hull surface. These are sort of long divots in the surface (you can see them near the bow). I'm not sure what causes them, perhaps not regular enough curves on my stations?

Michael, I read somewhere that Rhino has a "rebuild surface" command. Would that help this situation now that I have gone too far to start again? Is such a thing planned for MoI? I'm guessing it works like rebuild curve but for surfaces?


Image Attachments:
Size: 50 KB, Downloaded: 123 times, Dimensions: 1150x684px
Size: 43.8 KB, Downloaded: 105 times, Dimensions: 1150x684px
Size: 38.2 KB, Downloaded: 87 times, Dimensions: 1150x684px