Hi Aaron,

> (i.e. so that the lofted surface would actually be touching these curves)?

You can use the Network command instead of Loft if you want to have curves in 2 different directions be applied to the resulting surface.

Network is kind of like doing a loft through 2 directions at the same time - you select all the curves at once and then run Network. The curves need to form a kind of grid pattern.


Or you can also use Sweep in some kinds of cases as well - sweep drags a profile along guide rails, and you can select multiple profiles instead of only 1 profile and that will make the profiles kind of morph from one to the other as it is dragging along the rails.


But both Network and Sweep can use curves going in 2 directions while the Loft command only uses curves going in 1 direction.

- Michael