Here is a sample of what I had in mind.
Which does not mean that there can be any variation of that....
Just an idea for the ones who cannot imagine what I was referring to...

PaQ's model looks great, except it's two of them. I'd have difficulty machining it.
The model must be a little bit more 'cylindrical' in nature.
Imagine a 4Inch diameter max and a 12-15 inch height.
That volume can conveniently be machined.
I could drill a hole through it and mount a light bulb on top haha.

But.... do not hesitate to create a Plaque based on the logo itself.
In that case imagine something within a 12x12Inch height and width and a maximum of 1 inch thickness.

If you stick to the ratio, I'll scale it to fit later. No worries.



Cheers
Rainer