Hi telnoi,

> Issue, the fillet radius is limited due to the construction of the loft.

If you could post a 3DM model file with the lofted surfaces in it, that may help me understand what issue you were running into here.

Maybe you are trying to loft around a tight bend, when you may need to instead make that a sharp corner and rely on filleting to round it off as well as the other corner?


I would probably normally think of doing what you show there with filleting like Burr shows.

Some other ideas from some previous posts:

http://moi3d.com/forum/index.php?webtag=MOI&msg=2164.2
http://moi3d.com/forum/index.php?webtag=MOI&msg=2164.4

- Michael