Feature Request: Close Openings

 From:  ghan
Hi Michael,

Here's a feature request...How about a tool to close up openings (such as holes, cuts through solids ?)

SpaceClaim has included this tool and it works very well for removing slots, holes, cuts etc with a single click.

Often times I find that I want to remove such a feature from a model and the only way to do this is to create a solid "plug" feature and then do a boolean add. This usually leaves phantom tangent lines left remaining in the solid that I would prefer would not be there.

Perhaps this has been discussed previously, but I did not locate the topic.

Best Regards,