Hi Michael ..

This seems like a rudimentary question but I can't seem to work out the answer.

It seems that if I keep the original wall base lines that I can then turn on the control points and simply move a selected set of them to elongate a wing of the house ... say by 4 feet.

But if these have been deleted it does not seem that the same operation is possible. I know that I can elongate the entire group of walls with the scale box (or whatever it is called) but all the offsets in the layout move equally in both directions.

Suppose that after the model is fairly far along the client asks that the living room be made longer ... is there a simple way to do that?

thanks
eric