Hi Burr,

> though, I want the symmetrical path for 7/8 the length and the
> "squish" for the last 1/8.

There isn't any way to do maintain height only for just a portion of the sweep, it's either on for the whole sweep or off for the whole sweep.

But you could do the sweep in 2 portions if you want, with different options set for each portion, will that do what you need?

I'm sorry I can't quite follow what you want from those images, they're kind of dark. Is there any way you can describe it a bit more?

It may be possible for the case you are talking about here where you want shifts in behavior at different spots in the rail, that using multiple profiles would be a better way to go than using a scaling rail, but I'm still just not quite sure what your desired end result is though.

- Michael