sudoku ? (need some help/advice how to close a surface)

 From:  DannyT (DANTAS)
1608.2 In reply to 1608.1 
Hi PaQ,

This is my attempt before I go to bed. If this is what you want, it's something like extract some edges blend them make sweep,
then extract more edges, blend with buldge @ 0.35 I think then project this onto other sweep, then sweep these then trim the 2 rads
to each other -> done.
sorry for the bad explanation, if no one explains it better I'll let you know in about 7 or so hours, sorry need sleep.....zzzzzzzzzz.


By the way, nice model, I knew inside computers were evil !!

EDITED: 20 May 2008 by DANTAS