Hi Brent, just getting back to some of your questions.
> Say, would you be able to refer any good 3-D printing
> resources? I have taken some of my CAD work (actually
> stuff created on MoI =) to rapid prototype places. This
> gets kind of expensive.
Check out this thread:
http://moi3d.com/forum/index.php?webtag=MOI&msg=1410.1
I think Phil and Crusoe mentioned some resources there for doing pretty low cost 3-D printing.
> Have you ever considered licensing MoI for school use?
Yup, I do have a program for this which is pretty informal right now and I just handle it on a case-by-case basis right now. Send me an e-mail at moi@moi3d.com when you have a lab set up and I can give you some more information on that.
- Michael
|