Hi Petr,
> Anyway, is there any snag in it to use it for sweeping without auto-place mode?
Just possibly some extra work to set up non-auto-place mode since they go through somewhat separate code paths. But maybe with a bit of re-arranging it would not be a problem to enable it for both types.
> Will it work in case of multiple pair-of-profiles? (top part of the image below)
Yup, I don't see any problem with that. If you use a pair of profiles in one spot, then you'll have to use pairs throughout though.
Also if you use multiple proflies I think you'll only be able to have one hole inside of them. With a single profile multiple holes would work (like imagine a circle with 3 small circles inside of it as holes), but with multiple profiles it will be hard to figure out how to match things up.
> And will the resulting objects be editable using history mechanism or
> it will break a history on the object like custom command Pipe does?
It should work fine with history.
- Michael
|