MoI discussion forum > Is there a way to avoid having sharp edges (Kayak edges) after you join two surfaces created using network?

Is there a way to avoid having sharp edges (Kayak edges) after you join two surfaces created using network?

From:

13 Jul 2020 (5 of 14)

9881.5 In reply to 9881.1
Hi DrillBit, can you please post your .3dm model file? Usually the best way in MoI to avoid sharp edges is to make one single larger Network instead of doing it in smaller sections. If you do it in sections you will end up with sharp corners between each section. - Michael