Hello MoI friends,

I figured that I would create a new thread, as my question doesn’t necessarily relate to my previous post.

Relating to the Node Editor, I was wondering if there is a node combination that would allow me to orient a selected solid to the orientation of a surface, preferably orienting to the surfaces normals? I have tried a few node combinations and have got close enough to have the solid match the target surfaces position (I think I used an orient node), but it didn’t seem to match the surfaces normal?

In theory, it shouldn’t be a very complex task, I have looked through the previous node editor posts to find something similar, but haven’t really found anything?

Thank you for kindly taking the time to read and I hope you’re all finding your creativity during this isolating time.

Tim