Hi Pilou,

re:
> In the successive method you can't because you can't (for the moment) kill a fillet for change it(s)!
> So you must all remake! :)

There is a very simple solution for that, just save off a version of your model before you put the fillets on. If you decide you don't like one of the previous fillet steps then just load in your previous model and do new fillets on it. It isn't necessary to rebuild everything then.

In the future though I do want to have "edge sets" in the fillet command in addition to "point sets", so you could set different fillet radius values on different edges and adjust them before leaving the fillet command.

- Michael