Anybody to give me some quick direction here. I just went to rebuild this nod that frenchy shows (Revolve emulated).

I couldn't find how to add the "Output" node. I think I right clicked and went through all the options, but I could have missed it.

I can load the node frenchy links to and it works fine. Maybe I don't have a full node editor install? I haven't been following it well.

Thanks.

[EDIT] Found it. My NodeEditor window was sized down a bit, and the "Output" node, which is the upon start ofg a new project, was sitting, hidden off to the side. [EDIT]

Thanks again.