Start up .js worked perfectly to keep the pallets open. Thanks.


Ok back to the loft/fillet question :-) Sorry!
I have created a test file which has 3 sets of curves to loft (Green, Blue & Red).

Red curves was rebuilt version of blue curves.
Green and Blue curves were hand built.

After lofting...

1- I can apply CONSTANT DISTANCE fillet of 3 units on all surfaces at the lower part.
2- On the highlighted upper part I can apply CONSTANT DISTANCE fillet of upto 6 units on the green model but absolutely nothing on the blue and red model.
3- The 6 unit fillet that I can apply on the green model's upper part results in pinching in the corner though. I understand when you said that dense geo on the corner etc but here it does not seem dense or going in odd directions.

I am trying to get my head around this as same type of issue keeps cropping up for me and I end up going around in circles lol.

Thanks you.