Hi Metin,

i think this is most interesting when it comes to NURBS conversion, after auto-retopo...

I did a quick test and re-meshed the bunny with QuadriFlow and i think also with a higher
resolution and now after converting with Fusion360 i have much fewer patches than with
my old NURBS bunny and also more definition in the NURBS surface... :-)

I think i must do a better comparison again, with creating new bunny meshes and then
converting, to get a better picture, but i strongly believe it has to do with the fewer
singularities QuadriFlow produces.

The left bunny in my picture has 183 surfaces, while the right bunny has only 112! :-)



Regards
Stefan