Hi All

I thought I would post my 3d print experience with this model. Very cool to see a design come to life and the shape and dimensioning are good, however I have ended up with a course or aliased finish as the attached photos show. I exported my model to STL with 6 degree angles, just wondering if anyone could suggest what setting I actually should have used? Also its fairly obvious I did not make the tail thick enough and with the lack of detail it has actually 'faded out' and not been printed in places!

Of course the printer is a major part of the equation, however I have seen/felt some of his other prints and they are much smoother than mine even where curved.

Any suggestions would be much appreciated, as I'm keen to make this work.

Cheers, Brendan.