Thanks Michael. I really appreciate all the personal attention.

BTW, I think I've found a simpler way to accomplish what I want for this project. I may set the configuration that you put together so I can learn this method too.

Here's what I did. Let me know if I'm a little crazy.

1. I drew the profile curve in the plane of the cross section.

2. I extruded this curve into a trimming surface, but set the direction parallel to the armrest slope.

3. I had to extend the curve a little to trim the entire armrest area, but I can just tweak in the right view. (I learned a bit more about the extrusion command.)





Thanks for all the help. I think I can move on to the filleting/roundover step shortly.

Jeff