Top 5 Features list for V3 !

 From:  Michael Gibson
3628.412 In reply to 3628.411 
Hi Ditto,

re #1 -
> The "Offset Curve" command could accept negative numbers for inward and positive numbers for outward direction.

The problem with that is that open curves (like say a line for example) do not particularly have any specific "inward" or "outward" directions to them.

So that's why it asks you to pick a point on which side you want to offset to, that makes the command work with all kinds of curves and not only on closed curves alone.


re: #2 -
> 2/ Long shortcuts:

I think you're asking for the equivalent of a "command alias" in Rhino, is that correct? That's like a short name that you type in but that can internally expand to a longer name.

I wouldn't really see putting a type-in alias right in the shortcut keys UI since just in general MoI is not so focused on typing in command names, but I can probably set up a section of the moi.ini file where you could enter in some aliases.

- Michael