And finally number 5.. Extend surface tool.. This can be seen in a video here:

http://youtu.be/tv40aawZAY4

You can go straight to 30 seconds in to spare yourself the entire video.

Basially extending a surface continuing the edges curvature. Could be great for patch modeling.

I'll get my own beer, thanks!

As a side note, he has done a good job with his blend command in relation to what I was describing in my previous request about blend bulge. Hes has those options and a couple others.. He also has the UV thing I was just speaking about (Although not IsoCurves. I think he's rebuilding the surfaces) The video shows this just after the extend surface part...

Good luck Michael with your V3 work and future release!