Hi, thanks for the explanation - yes, I've run across situations like that and deleting the extra point(s) is usually good enough.


When you put in the object type display (solid, surface, curve etc.,) it gave me a much higher level of confidence when working on my various objects. I knew if I didn't see "Solid", I knew there was a hole in my object somewhere that would cause me problems later.

Little segments like that makes me wish there was a diagnostic tool or a way to highlight little slivers or perhaps have a tolerance that could be set that would avoid adding segments below a certain length to help avoid issues that crop up from things like this.

I guess you really have to be diligent and can't just eye your models like you mentioned.

-Will