Hi Michael....


>I was thinking a bit about making the command go in a loop
>to allow you to keep picking new distances and new edges
>without repeating the whole command.
>But then that would make you do an extra action
>to finish the command in just the simple case where you just want to apply one distance...

Good idea michael, more & more faster...

>One note - one thing that does not work is if your base point
>that you first pick is exactly on the target line that you specify
>next (like if the circle center was already directly on the line).
>It doesn't know which direction from the line it should move towards in that case.

Yup, i think this behavior is same in SW. When a the center of circle already connected with a line ( concident ), then we cant move the circle in a specific direction. Because the circle already constraint with the line.

No problem ( at least for me ).

Now, I am looking for your another work / idea on "object management / properties".
Maybe next week ???

Thanks Michael,

-Anis