Hi Paul,

>>>what I meant was does your CAM system support 4axis because I believe Ed may well be looking for that facility as an example?

I have been digging through my software, up to now I have found Edgecam (version 5) and Mastercam (version 9.1), I have used both in the past.
I will have to take a little time to refresh with these applications, it has been a while, but I do remember Mastercam having up to 5 axis toolpaths, but it was limited. As I say, I will have to re-look.


Ed, what is the 4th axis on your machine?




- manz