Proportional Editing for Moi's Organic Surface

 From:  Frenchy Pilou (PILOU)
11741.33 In reply to 11741.32 
Where are you stuck in the Burman videos ?
First is just move the Control points of the curves!
Don't kill the original curve when you have made a function! (here an extrusion)



About the Flow Function! You can take any volumes, surface etc...
Copy the "start" under surface
The littel trick is to select the object result then call the History! ;) Not intuitive but that works fine!
You can add points on the surface target before the Flow but object will be deformed...

(don't kill or modify the original Object and surface)
No more simple and speedy! (and i have an more 12 years old latop! ;)

EDITED: 27 May by PILOU