CURVE TANGENCY - CONTINUITY RESOLUTION

 From:  BurrMan
11690.17 In reply to 11690.16 

Thanks for follow up Alex. I will certainly look over you outpit and locked tan files a bit later.

With my last post and just “looking at the screenshot” in your last post, it appears that last arc is greater than 180? (Havent verified this yet)

If it is, try adding a couple trim points to make it 2 or 3 smaller arcs and try it without the locked tan process to see if yyspipebender will accept that….

I’ll respond again after i get a look at the stp file output