Hi Billabong,

re:
> Is there a way to avoid this or a faster way to find this type of stuff? This can
> really throw a wrench in your production.

It can be pretty hard to find these, sorry. To avoid it try to keep your initial curve setup as clean and simplified as possible, try not to have duplicate curves or little tiny segments in the curves.

Any irregularities in initial curves will tend to inherit on down the line.

If you have repeatable steps that generates some bad stuff please send it over to me so I can see if I can stop it from happening. It's really hard to figure out exactly what previous step went wrong only by looking at the end result.

- Michael