Hi Michael,
Wanted to ask for some help.

I believe the image is only 2d. Done in a vector program or something. So the "Model" would actually look a little different. I think others have already shown a result.

But I wanted to fool around a bit with this.

I couldnt figure out the "Projection" with regard to how to rotate the 3d object. Used a CPlane and got it but then was still confused on where I was in WCS...

So the hexagon with center connected "cube" projection. I want to rotate an actual cube to that projection

Like 30 and 60 and 30 degrees or something.

If I cut the cube in half, I get 54.74 and 35.26 to equal 90. But I think i have left my level.

Can you help me with that?